Koso Digital/Analog Gauge

[s10custom]

Anybody seen any pictures of this gauge INEX has approved?

Thanks,
Robert

[justfreaky]

Robert,

What gauge is this. Not heard of this one.

Steve

[justfreaky]

Perhaps Randy, Jim or Dennis would know.

Steve

[VMS Motorsports]

I know nothing, dealers don't talk to me

[racerrad8]

I am installing one right now into a customers Thunder Roadster.

I do not know how it works yet as we have yet to finish the install or have an engine in the car to try it.

It is about 5 3/8 wide over all. It has the tach, shift light and tells you temp with a flashing over heat light.

I was told $210.00 from your dealer.

Randy - RPM

[s10custom]

Does it say INEX anywhere on it? Any results yet?

Thanks,
Robert

[s10custom]

Any one had chance to use or see one used yet?

Robert

[RPM]

I have seen and installed the one I took photos of in Feb. We installed it into a roadster rebuild we are still working on.

We are awaiting a new, custom seat before being able to get it out on the track.

It is all hooked up and the tach works here in the shop, still have to get it all programmed for the shift light.

I have another one on the shelf to install into another car in the next couple of weeks.

I can supply them for $199.95 if interested; USLCI sells them for $210.00.

Randy - RPM

[RPM]

Now on the shelf.

http://www.rpmracingca.com/proddetail.asp?prod=INEXTach

Randy - RPM

[late8]

how much does it weigh?

[RPM]

The gauge itself weighs 7.6 ounces, at this time there are no INEX markings anywhere on them.

[Belanger24]

Did anybody figure out how to hook up this tach to a red box ignition on a legend car?

[RPM]

Did anybody figure out how to hook up this tach to a red box ignition on a legend car?

We have installed several. The signal wire from the tach hooks to the yellow wire from the red box wire loom.

As always, in stock and cheaper than INEX offers: http://www.rpmracingca.com/proddetail.asp?prod=INEXTach

Randy - RPM

[Belanger24]

What are the settings that need to be put in the tach? I thought I had it set right but I'm not sure.

[Belanger24]

I set mine at P-1 HiAcct seems to be working well. I also connected to the yellow wire as you stated from the Red Box.