Author Topic: rear end offset problem  (Read 5528 times)

Offline jnally35

  • Newbie
  • *
  • Posts: 11
rear end offset problem
« on: May 12, 2016, 09:59:47 am »
So I am trying to square my rear end and I want to set my offset but the frame right under my axle housing on the left side is bent in so I cant get a true measurement to make sure I am legal. Is there a way to make sure I am within the 6" minimum on the left side.




Offline justfreaky

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4512
Re: rear end offset problem
« Reply #1 on: May 28, 2016, 04:15:22 pm »
Replace the rear clip.

You might be able to use a straight edge at points that are straight and string  (or measure) out from those points. That is assuming you have ant straight points to measure from.

Steve
Better to be hated for who you are, Than to be loved for who you are not.